DPA Microphones 2011A Stereo Pair With Clips and Windscreens in Peli Case

$132.89

SKU: SKU1500000408467 Categories: Condenser Microphones, Mics & Wireless Tag: DPA Microphones Brand: DPA Microphones

Description
Reviews (0)

The DPA Microphones 2011A Stereo Pair mics are acclaimed for their close-miking excellence and hi-SPL handling. Optimized for onstage use, these mics have been used on many stages as well as recording sessions. They exhibit a previously unheard blend of clarity, richness and dynamic range. The off-axis response is linear but in a smaller frequency bandwidth. This makes stage separation and gain-to-feedback higher, and the mic level is easier to control.

The foam design in the heavy-duty transportation box allows for fast and easy exchange of the microphone/accessory inlays.

The wide and versatile pencil mic series is legendary in the high-end recording and film production industry. Delivering clean, accurate sound, the mics in this series are used by professionals, who understand sound and insist on only using the best.

Modularity – interchangable capsules and preamplifiers
Up to 120 dB dynamic range
RF rejection between >60 and >40 dB
Linear frequency response
High SPL
Superior gain before feedback

Directional pattern: Cardioid
Principle of operation: Pressure gradient, with interference tube
Cartridge type: Pre-polarized condenser, Twin Diaphragm Capsule
Frequency response: 20 Hz – 20 kHz
Effective frequency range, ±2 dB, at 30 cm (11.8 in): 50 Hz – 17 kHz with 3 dB soft boost at 12 kHz
Sensitivity, nominal, ±2 dB at 1 kHz: 10 mV/Pa; -40 dB re. 1 V/Pa
Equivalent noise level, A-weighted: Typ. 20 dB(A) re. 20 µPa (max. 23 dB(A))
Equivalent noise level, ITU-R BS.468-4: Typ. 33 dB (max. 36 dB)
Distortion, THD < 1%: 134 dB SPL RMS, 137 dB SPL peak
Dynamic range: Typ. 117 dB
Max. SPL, THD 10%: 153 dB SPL peak
Switchable attenuator, filters etc.: 0 dB / -20 dB
Rated output impedance: 200 Ω
Minimum load impedance: 2 kΩ
Cable drive capability: 100 m (328 ft)
Output balance principle: Impedance balancing with Active Drive
Common mode rejection ratio (CMRR): > 60 dB
Power supply (for full performance): P48 (Phantom Power)
Current consumption: 2.8 mA
Connector: XLR-3M. Pin 1: shield, Pin 2: signal + phase, Pin 3: – phase
Color: Matte black
Weight: 164 g (5.8 oz)
Microphone diameter: 19 mm (0.75 in)
Microphone length: 198 mm (7.8 in)
Maximum output voltage, RMS: 8 V
Polarity: +V at pin 2 for positive sound pressure
Temperature range: -40°C to 45°C (-40°F to 113°F)
Relative humidity (RH): Up to 90%
Sensitivity selection tolerance (at 1 kHz): ±1.5 dB

Reviews

There are no reviews yet.

DPA Microphones 2011A Stereo Pair With Clips and Windscreens in Peli Case

Reviews

Be the first to review “DPA Microphones 2011A Stereo Pair With Clips and Windscreens in Peli Case” Cancel reply

Related products

Login